Retired - Kylie Post Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Place your Celtic eternity connector bead down flat (you can pick either side since both sides are the same) and add a dab of E-6000 glue onto the center.
2. Take your gold plated earring post and place it onto the glue, flat side down.
3. Hold it in place for a few seconds then set aside allowing the glue to dry.
4. Once the glue is dry, flip over your earring, and add a tiny dab of E-6000 glue onto the center.
5. Using your tweezers, pick up one Austrian crystal flatback rhinestone in Fern Green and place it on top of the glue, flat side down.
6. Once the glue is dry, add an earring back.
7. That's it!

• FCO-4731 - TierraCast Fine 22K Gold Plated Pewter Celtic Eternity Connector Beads 17mm (2)
  Project uses 2 pieces. You will need 1 package.


• SWF-420150 - Austrian Crystal, Round Flatback Rhinestone SS20 4.6mm, 50 Pieces, Fern Green
  Project uses 2 pieces. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.


• FEA-1615 - Gold Plated Flat 6mm Glue On Earring Posts (10 Pairs)
  Project uses 2 pieces. You will need 1 package.


• FEA-1015 - 22K Gold Plated Earring Backs (Earnuts) Med. (100)
  Project uses 2 pieces. You will need 1 package.

• XTL-4000 - Beadsmith Bead And Pearl Knotting Tweezers