Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
In addition to the materials listed, you will also need a toothpick or scrap of wire. By following the instructions below you will make one earring. Repeat all instructions to make the second earring.
- Take a bit of E6000 glue on the tip of a toothpick or a scrap of wire. Dab the glue around the inner edge of 1 Nunn Design open back bezel. Take 1 Austrian crystal crystal chaton and press it into the bezel. Let the glue dry for 14-16 hours, or overnight.
- Using flat nose pliers, open the loop on the end of one ear wire the same way you would open a jump ring. Slide on the loop at the top of the open back bezel charm, with the crystal facing forward. Close the loop of the ear wire.
- Enjoy your earrings!
WHAT YOU'LL NEED: (scroll down for purchase options)
- PND-906 - Nunn Design Open Back Bezel Charm, Circle 12x16mm, 1 Piece, Bright Silver
Project uses 2 pieces. You will need 2 packages.
- SWCH-639563 - Austrian Crystal, 1088 Xirius Round Stone Chatons ss39, 6 Pieces, Scarabaeus Green
Project uses 2 pieces. You will need 1 package.
- FEA-108 - Nunn Design Earring Findings, Open Oval Hoop Ear Wire with Loop 15.5x44mm, 1 Pair, Bright Silver
Project uses 2 pieces. You will need 1 package.
- XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
Project uses 1 piece. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose