Retired - Jeweled Decadence Cuff

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Cut the following lengths of black Czech glass cup chain using your flush cutters: four 11 cup long lengths and three 13 cup long lengths. Set aside for now.
2. Next, referring to the photos often, carefully begin gluing down your faceted cabochons onto the raw brass cuff. Add a dab of E-6000 glue starting at the center and place 1 black 13x18mm cabochon vertically onto the glue.
3. Add a thin line of glue surrounding the cabochon and carefully wrap a 13 cup long length of black cup chain around the cabochon, placing it on the glue.
4. Next, glue on a gray 10x14mm cabochon and surround it with a cup chain length that is 11 cups long. See photo for placement assistance.
5. Continue referring to the photo and mimic my design, remembering to leave enough room around each cabochon for your black cup chain lengths. Glue on the rest of your cabochons and cup chain. See photo,
6. Once all your components are glued on, set aside to dry.
7. Enjoy!

• JB-2566 - Solid Brass Domed Cuff Bracelet Base 37mm Wide (1 Piece)
  Project uses 1 piece. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.


• BGL-02012 - Mirror Back Glass Cabochons, 10x14mm Faceted Ovals, 4 Pieces, Light Grey
  Project uses 4 pieces. You will need 1 package.


• BGL-02004 - Flat Back Glass Cabochons, 13x18mm Faceted Ovals, 4 Pieces, Jet Black
  Project uses 3 pieces. You will need 1 package.


• CHA-10113 - Czech Crystal Brass Rhinestone Cup Chain 24PP Jet Black (By The Foot)
  Project uses 1 foot. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex