Retired - Iridescent Ice Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Place the two stampings together with the rough sides facing each other, sandwiching the rivoli in between.
2. Open eight of the smaller jump rings and thread them through the holes, connecting the two stampings as shown in the photograph. Close the jump rings again.
3. Cut two pieces of chain at eight inches long each.
4. To one end of each piece of chain, add a large jump ring.
5. To the other end of each piece of chain, add a small jump ring.
6. To one of the small jump rings add one half of the toggle, to the other small jump ring add the other half of the toggle.
7. Thread the two large jump rings through the joined stampings about an inch apart from each other, as shown in the picture. Close all jump rings.

• PND-5711 - Antiqued Silver Plated Ornate Wreath Filigree Stamping 48mm (1)
  Project uses 2 pieces. You will need 2 packages.


• FCL-7048 - TierraCast Silver Plated Pewter Keepsake Toggle Clasp 16mm (1)
  Project uses 1 piece. You will need 1 package.


• SWC-9451 - Austrian Crystal, 1122 Rivoli Fancy Stones 18mm, 2 Pieces, Crystal AB Sf
  Project uses 1 piece. You will need 1 package.


• FJR-5140 - Silver Plated Open Jump Rings 4mm 21 Gauge Thick (100)
  Project uses 10 pieces. You will need 1 package.


• FJR-5180 - Silver Plated Open Jump Rings 8mm - 18 Gauge (100)
  Project uses 2 pieces. You will need 1 package.