Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
You can use either round nose pliers or wire looping pliers to make your simple wire loops for this project.
- Onto your head pin, please place the following beads: 1 large bicone bead, 1 teddy bear bead, 1 small bicone bead.
- After the last bead, create a simple wire loop. Trim off excess wire.
- Open the loop at the base of your earring hook, the same way you would open a jump ring, and link onto it the loop of the bead segment you just made. Close the loop.
- Repeat steps 1 - 3 to make your matching earring. Hugs!
WHAT YOU'LL NEED: (scroll down for purchase options)
- BMB-3383 - TierraCast Fine Silver Plated Pewter Teddy Bear Beads 14mm (2 Pieces)
Project uses 2 piece(s). You will need 1 package(s).
- PRES-5328-LRO8 - PRESTIGE Crystal, #5328 Bicone Bead 8mm, Light Rose (1 Piece)
Project uses 2 piece(s). You will need 2 package(s).
- PRES-5328-LROS6 - PRESTIGE Crystal, #5328 Bicone Bead 6mm, Light Rose Shimmer (1 Piece)
Project uses 2 piece(s). You will need 2 package(s).
- FHP-3003 - Head Pins, with Ball Head 3 Inches Long and 21 Gauge Thick, Silver Plated (20 Pieces)
Project uses 2 piece(s). You will need 1 package(s).
- FEA-3070 - Earring Findings, French Wire Hooks 22mm, Silver Plated (25 Pairs)
Project uses 1 pair. You will need 1 package(s).
RECOMMENDED TOOLS:
- XTL-5032 - The Beadsmith Wire Looping Pliers - Concave And Round Nose
- XTL-5450 - Xuron Jeweler's Super Fine Pliers Chain Nose Flat Nose
- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire (1 Piece)
- XTL-0020 - Baby Wubbers Quality Fine Chain Nose Jeweller's Pliers