Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
- Take the brass filigree square (FCO-7050), and locate the small circles along the outer edge, and at the center of each of the four sides. With your chain nose pliers gently bend the small circle in the center of the edge back and forth until it comes off. Do this to all four sides (see photo).
- Place the silver plated filigree square (PND-5717) face down. Bend up the swirls at the very narrowest part of the "arm" at a 90-degree angle. Now place the brass filigree square (FCO-7050), face down on top of the silver square so the swirls will fit nicely in the section where you snipped off the center circles of the brass filigree. Bend down the swirls of the silver filigree square so they lay flat on the back of the brass filigree piece (see enlarged photo).
- Open the larger brass open jump ring (FJR-5372). Link through any one of the top holes on the corner of the brass filigree piece. Close jump ring.
- Open one of the smaller open jump rings (FJR-5340). Link onto the end link of the brass chain, the end link of the silver plated chain and the end loop of the clasp hook. Close the jump ring. (See the enlarged project photo that includes the chain for a detailed view)
- Open the other smaller open jump ring. Link onto the other end link of the brass chain, the end link of the silver plated chain and one of the loops of the clasp end. Close the jump ring.
- Thread the chain through the larger open jump ring on the pendant.
- The last step is to glue an Austrian crystal flatback (SWF-12110) on the front center of the silver filigree square with E6000 glue (XTL-1051). You can use a toothpick for precision application. Allow it to set over night for optimum adhesion. You're finished!
WHAT YOU'LL NEED: (scroll down for purchase options)
- FCO-7050 - Antiqued Brass Square Filigree Stamping 35mm (2)
Project uses 1 piece. You will need 1 package.
- PND-5717 - Antiqued Silver Plated Filigree Stamping Dapt Scroll Cross 43mm (1)
Project uses 1 piece. You will need 1 package.
- CHA-9646 - Antiqued 22K Gold Plated Krinkle Chain 2mm Bulk By The Foot
Project uses 18 inches. You will need 2 packages.
- CHA-9645 - Antiqued Silver Plated Krinkle Chain 2mm Bulk By The Foot
Project uses 18 inches. You will need 2 packages.
- FJR-5372 - Vintaj Natural Brass Jump Rings 7.25mm Open 16 Gauge (20)
Project uses 1 piece. You will need 1 package.
- FJR-5340 - Vintaj Natural Brass Jump Rings 4mm Open 21 Gauge (25)
Project uses 2 pieces. You will need 1 package.
- FCL-4642 - Vintaj Natural Brass Tiny Hook And Eye Clasps 21mm (4 Sets)
Project uses 1 piece. You will need 1 package.
- XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
Project uses 1 piece. You will need 1 package.