Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
These instructions will give you a bracelet that measures approximately 7 inches.
- Start by cutting 1 foot of stretch magic. Place a bead stopper about 2 inches from one end.
- Open one jump ring and attach the jump ring to the Tree of Life pendant then close the jump ring.
- To thread you beads, you will use this order: 4 green adventurine, 1 Austrian crystal round gold bead, and repeat - 4 green, 1 gold, 4 green, 1 gold, 4 green. 1 gold, the jump ring attached to your pendant, 1 gold and 4 green, 1 gold.
- Remove the bead stopper and tie the ends of the stretch magic in a double knot.
- Snip the ends of the stretch magic to give you two 2" tails that you will thread back through the bracelet on both sides.
WHAT YOU'LL NEED: (scroll down for purchase options)
- SPAV-08 - Green Aventurine 8mm Round Beads / 15-16 In. Strand
Project uses 20 pieces. You will need 1 package.
- PND-7776 - TierraCast Brass Oxide Finish Pewter Round Tree Of Life Charm 19mm (1)
Project uses 1 piece. You will need 1 package.
- SWC-0611 - Austrian Crystal, 5000 Round Beads 6mm, 10 Pieces, Crystal Dorado 2X
Project uses 6 pieces. You will need 1 package.
- FJR-5156 - Antiqued Brass Open Jump Rings 5mm 18 Gauge (50)
Project uses 1 piece. You will need 1 package.
- XCR-2175 - Stretch Magic Clear Stretchy Cord .7mm/.028 Inch Width - 5 Meters
Project uses 1 foot. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5700 - Fiskars 5 Precision Tip Scissors - Super Sharp
- XTL-3000 - Bead Stopper- Stop Beads Sliding Off Stringing Material
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose