Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
- Use your chain nose pliers to slightly bend up 3 corners of the square filigree (PND-7028). (HINT: the square is dapped or indented already so the corners will already be bent slightly upward)
- Lay the Rivoli crystal (SWC-9303) face up into the center of the square. It will lay right inside the dapped indentation nicely. Hold the rivoli with your fingers while you bend over 2 of the sides (opposite sides) pressing them gently on top of the rivoli crystal.
- Now take the bottom corner with your fingers and gently push it up against the, but not over the rivoli.
- Take your chain nose pliers and bend the tip of the bottom corner of the square back down slightly. This will allow you to hang a dangle.
- Open a 4mm jump ring (FJR-5347). Link on a filigree charm (PND-7114). Link onto the bottom of the square filigree corner. Close jump ring.
- Open the loop at the bottom of the leverback earring piece. Link on the top corner of your finished piece (FEA-6014) (see photo) Close loop.
- Repeat the steps above to make the second earring.
WHAT YOU'LL NEED: (scroll down for purchase options)
- PND-7114 - Vintaj Natural Brass Filigree Teardrop Charms 12mm (2)
Project uses 2 pieces. You will need 1 package.
- PND-7028 -
Project uses 2 pieces. You will need 1 package.
- FEA-6014 - Antiqued Brass Earrings Leverbacks With Shell (5 Pairs)
Project uses 2 pieces. You will need 1 package.
- SWC-9303 - Austrian Crystal, 1122 Rivoli Fancy Stones 12mm, 4 Pieces, Black Diamond Sf
Project uses 2 pieces. You will need 1 package.
- FJR-5347 - Vintaj Natural Brass Jump Rings 4.75mm Open 19 Gauge (25)
Project uses 2 pieces. You will need 1 package.