Retired - Gold Breathe Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by finding the center of the finished chain. Using your flush cutters, cut the center link.
2. Open one oval jump ring and attach one end of the chain to one loop of the connector bar. Close the jump ring. Repeat on the other side.
3. All done!

• FCO-1293 - TierraCast Pewter, Connector Link with Breathe Text 40x11.5mm, 1 Piece, 22K Gold Plated
  Project uses 1 piece. You will need 1 package.


• AXC-0002 - Gold Plated Flat Fine Cable Chain Necklace - 2x1.5mm Oval Links (16 Inches)
  Project uses 1 piece. You will need 1 package.


• FJR-3917 - 22K Gold Plated Open Jump Rings Oval 5x8mm 21 Gauge (50)
  Project uses 2 pieces. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers