Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
- Onto a eyepin thread a daisy spacer, a 12mm open leaf bead cap, a 28mm glass bead, another 12mm open leaf bead cap, and finally another daisy spacer.
- Make a simple loop at the end, and trim off excess wire.
- Thread two additional eyepins with the following: a 7mm bead cap, a glass drop bead, and a 3.5mm cone flower bead cap. Create a simple loop at the opposite end of each and trim off excess wire.
- Open the loop at the bottom of each drop bead and thread each loop through the loops at either end of the large glass bead. Close the loops once again.
- Open the loop at the narrow end of one of the drop beads and thread it through the loop on the bell bead. Close the loop again.
WHAT YOU'LL NEED: (scroll down for purchase options)
- BGL-1942 -
Project uses 1 piece. You will need 1 package.
- BMB-6454 - 22K Gold Plated Open Petal Flower Bead Caps 7mm (50)
Project uses 2 pieces. You will need 1 package.
- BMB-6460 - 22K Gold Plated Cone Flower Bead Caps 6mm x 3.5mm (50)
Project uses 2 pieces. You will need 1 package.
- BMB-6466 - 22K Gold Plated Filigree Open Leaf Bead Caps 12mm (12)
Project uses 2 pieces. You will need 1 package.
- BMB-3219 - TierraCast Fine Bright 22K Gold Plated Pewter Daisy Spacer Beads 4mm (50)
Project uses 2 pieces. You will need 1 package.
- BMB-5197 - Gold Color Steel Hollow Jingle Clapper Bell Beads 6mm (100)
Project uses 1 piece. You will need 1 package.
- FHP-6220 - 22K Gold Plated Open Eye Pins 21 Gauge 2 Inches (x50)
Project uses 3 pieces. You will need 1 package.