Retired - Gia Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Using your flush cutters, cut a strip of Opaque Yellow cup chain that is 9 rhinestones long, a strip of Opaque Red cup chain that is 7 rhinestones long, and a strip of Turquoise cup chain that is 9 rhinestones long.
2. Next, while the bar on your bangle bracelet is still closed, add a thin line of Hypo Cement glue across the top portion. This is where your first strip of cup chain will go. See photo for placement assistance.
3. Carefully place your strip of Opaque Yellow cup chain onto the glue with the rhinestones facing up. Your strip should fit the length of the bar on your bracelet.
4. Add another thin line of Hypo Cement glue beneath that first strip of Yellow cup chain, and glue on your strip of Opaque Red cup chain, making sure to align your cup chain lengths so they are straight.
5. Add another thin line of glue and place your third strip of Turquoise cup chain onto it.
6. Set your bangle aside to dry, with the bar facing up.
7. Enjoy!

• CHA-10144 - Czech Crystal Brass Rhinestone Cup Chain 24PP - Opaque Red (By The Foot)
  Project uses 1.25 inches. You will need 1 package.


• CHA-10145 - Czech Crystal Brass Rhinestone Cup Chain 24PP - Opaque Yellow (By The Foot)
  Project uses 1.25 inches. You will need 1 package.


• CHA-10123 - Czech Crystal Brass Rhinestone Cup Chain 24PP Turquoise (By The Foot)
  Project uses 1.25 inches. You will need 1 package.


• JB-2514 - Solid Brass Bracelet Base, Rectangle Swing Top 39x8.5mm, 1 Piece
  Project uses 1 piece. You will need 1 package.


• XTL-1001 - G S Hypo Cement Precise Applicator Essential!
  Project uses 1 piece. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex