Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
This bracelet is adjustable. When sizing, simply measure the largest size needed to slip over the wrist. From there you will add the adjustable slider bad to wear comfortably. To modify the length, simply adjust the length of chain on both sides respectively. You will also need a scrap of thin wire and a toothpick for this bracelet.
- Cut two 4.5 inch lengths of chain.
- Open one jump ring and attach it to the end of one length of chain. Attach one eye setting link and close the jump ring. Move to the other side of this link and attach the other length of chain with another jump ring. Close the jump ring.
- Using your thin scrap of wire and thread on one end link of chain using this wire as a needle thread it through the adjustable slider bead. Remove the wire. Slip the wire onto the other end link of chain and thread it through the slider bead criss crossing it so that the chains are coming out opposite ends of the bead.
- Take one charm and attach it to the end of the chain using a jump ring. Repeat on the other side with a second charm.
- Place a dab of glue into the well of the setting and set the fancy eye stone into the setting. Allow to dry for at least 24 hours before wearing.
WHAT YOU'LL NEED: (scroll down for purchase options)
- BMB-021 - Adjustable Slider Clasp, Round with Silicone Center 8mm, 4 Pieces, Gold Tone
Project uses 1 piece. You will need 1 package.
- CHA-0180 - Gold Plated Bulk Chain, Tiny Rectangle Soldered Cable Links 3x2mm, By The Foot, Bright Gold
Project uses 9 Inches. You will need 1 package.
- SWCR-4271 - Austrian Crystal, 4775 Eye Fancy Stone 18x10.5mm, 1 Piece, Digital Print Blue
Project uses 1 piece. You will need 1 package.
- SWCR-4273 - Austrian Crystal Fancy Stone Connector Link Setting, Fits Eye Fancy Stone, 1 Piece, Gold Plated
Project uses 1 piece. You will need 1 package.
- FJR-3914 - 22K Gold Plated Open Jump Rings 4mm 20 Gauge 22k Gold Plated (100)
Project uses 4 pieces. You will need 1 package.
- SWFA-1020 - Austrian Crystal, Gold Plated Channel Charm, 7mm, 8 Pieces, Crystal
Project uses 2 pieces. You will need 1 package.
- XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
Project uses 1 piece. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers