Retired - Ellie Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by cutting two lengths of Turquoise Czech glass cup chain that are 9 rhinestone links long each with your flush cutters. Set aside.
2. Next, add a few dabs of glue onto the center portion of your bracelet's glue pad and place your button cabochon onto the glue, flat side down. See photo for placement assistance.
3. Wait a few minutes to dry.
4. Next, add a thin line of glue around the button cabochon on your bracelet's glue pad. Carefully place one of your cup chain lengths onto the top portion and the second cup chain length onto the bottom portion. Try to align it against your button cabochon. See photo for placement assistance.
5. Keep your bracelet facing up to dry.
6. That's it!

• CHA-10123 - Czech Crystal Brass Rhinestone Cup Chain 24PP Turquoise (By The Foot)
  Project uses 3.5 inches. You will need 1 package.


• JB-2513 - Solid Brass Bracelet Base, Round Swing Top with 34mm Blank, 1 Piece
  Project uses 1 piece. You will need 1 package.


• SPCB-2306 - Czech Glass Flat Back Button Cabochons, Floral Design 27.5mm Round, 1 Piece, Red and Gold
  Project uses 1 piece. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex