Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the directions below, you will make one earring. Repeat all instructions to make the second earring.
- With your chain nose pliers, open a gold plated 8mm jump ring and slide it onto the loop on the bottom of your TierraCast earring stud and also the hole on your Austrian crystal crystal spike pendant. Close the jump ring.
- Cut a wire length of 10 inches with your flush cutters.
- Take your length of wire and using your fingers, wrap it around the top portion of your Austrian crystal crystal spike pendant as a decorate accent. If you would like a neater look, simply use your pliers for a tight wrap. See photo for assistance.
- Lastly, add on your gold tone hypo allergic earring back and you're done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- WNT-2433 - Beadsmith Tarnish Resistant Gold Color Copper Wire 24 Gauge 30 Yards (27.4 Meters)
Project uses 20 inches. You will need 1 package.
- FEA-1547 - TierraCast 22K Gold Plated Pewter Stud Post Earrings Beaded Round 11mm (1 Pair)
Project uses 1 pair. You will need 1 package.
- FJR-5477 - 22K Gold Plated Open Jump Rings 8mm 20 Gauge (50)
Project uses 2 pieces. You will need 1 package.
- SWCR-6000 - Austrian Crystal, 6480 Spike Pendant 18mm, 1 Piece, Crystal
Project uses 2 pieces. You will need 2 packages.
- FEA-1012 - Bullet Clutch Earring Backs, Hypo Allergenic 5.7x5mm, 50 Pieces, Gold Tone
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose