Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
- Remember to double all of the instructions in order to make both earrings. Onto a headpin thread the following:
- a tiny copper scalloped bead cap (BMB-3289), concave side up
- a 7mm copper open petal flower bead cap (BMB-6455), concave side up
- an 8mm two toned brown and crystal Czech fire polish bead (BCP-38100)
- a 6mm copper cone flower bead cap (BMB-6461), concave side down
- a 9mm copper plated triple point bead cap (BMB-3854), concave side down
- an 8mm copper plated granulated flower bead cap (BMB-3860), concave side up
- a 7mm copper open petal flower bead cap (BMB-6455), concave side up
- a 6mm two toned brown and crystal Czech fire polish bead (BCP-38100)
- another tiny copper scalloped bead cap (BMB-3289), concave side down
- Create a wrapped wire loop and trim off excess wire.
- Open the loop on the earring hook the same way that you would open a jump ring. Thread the earring hook loop through the loop on the headpin. Close the earring hook loop again.
WHAT YOU'LL NEED: (scroll down for purchase options)
- BMB-6461 - Genuine Copper Cone Flower Bead Caps 6mm x 3.5mm (50)
Project uses 2 pieces. You will need 1 package.
- BMB-3289 - TierraCast Copper Plated Pewter Scalloped Bead Caps 3.5mm (x 12)
Project uses 4 pieces. You will need 1 package.
- BMB-6455 - Genuine Copper Open Petal Flower Bead Caps 7mm (50)
Project uses 4 pieces. You will need 1 package.
- BCP-36100 - Czech Fire Polished Glass Two Toned Beads 6mm Round Brown Crystal (25)
Project uses 2 pieces. You will need 1 package.
- BCP-38100 - Czech Fire Polished Glass Two Toned Beads 8mm Round Brown Crystal (25)
Project uses 2 pieces. You will need 1 package.