Retired - Celestial Stamped Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. To see how to make this project, please watch the video: How to Make a Bride and Groom Metal Stamped Necklace. You will follow all the instructions in the video except that you will use black patina to fill in the lines of the stamping.
2. To use the patina, apply paint the patina over the stampings. Let dry for just a couple seconds and then wipe it off. What is left should be patina in the recessed area of the stampings.
3. Enjoy!

• PND-9028 - ImpressArt Soft Strike Stamping Blanks, Rectangle Shaped Pendant 38x8mm, 1 Piece, Pewter
  Project uses 1 piece. You will need 1 package.


• AXC-98926 - Silver Plated Fine Cable Chain Necklace with Lobster Clasp - 2x1.8mm Links 16 Inches Long
  Project uses 1 piece. You will need 1 package.


• FJR-5160 - Silver Plated Open Jump Rings 6mm 19 Gauge (x100)
  Project uses 2 pieces. You will need 1 package.


• XTL-9078 - Vintaj Patina Opaque Permanent Ink - Black Onyx - 0.5 Ounce Bottle
  Project uses 1 piece. You will need 1 package.


• SWFA-1009 - Austrian Crystal, Rhodium Plated Channel Charm, 7mm, 8 Pieces, Light Amethyst
  Project uses 1 piece. You will need 1 package.

• XTL-0020 - Baby Wubbers Quality Fine Chain Nose Jeweller's Pliers
• XTL-6236 - ImpressArt Steel Stamping Block, Small Size with Rubber Feet 2x2, 1 Piece, Steel
• XTL-0277 - ImpressArt Brass Hammer For Metal Stamping - 1 Pound - 1 Piece
• XTL-880 - ICE Resin, Angled Paint Brushes for ICED Enamels & Paper Sealant, 6 Pack
• XTL-0760 - Beadsmith 3 Piece Celestial Punch Set For Stamping Metal 3/16 Inch 5mm