Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
- Begin by cutting a 3' length of 2mm beige pleather cord.
- Place a 7mm, 18 gauge antique brass plated jump ring onto each of the holes in a maple wood laser cut butterfly pendant with purple stained cut out. Thread your cord through the jump rings to hang the pendant.
- Make an overhand knot in the cord about 2 1/2" up from the pendant on either side. Slide a lime green Golem Studio ceramic polka dot round bead onto each side of the cord above the knots.
- Make an overhand knot directly after each lime green bead.
- Make an overhand knot in the cord about 2" up from the last knot on either side. Slide a light blue Golem Studio ceramic polka dot round bead onto each side of the cord above the last knots.
- Make an overhand knot directly after each light blue bead.
- Bring the ends of the cord around, making the necklace into a loop with the ends overlapping. Tie an overhand knot about 1 3/4" from the end of one of the cord ends, catching the other strand of cord in the middle of the knot. Repeat with the other cord end. See photo for more information on how the knots should be arranged.
- Pull the knots nice and tight. You can then slide the knots back and forth on the strands to adjust the length of your necklace.
WHAT YOU'LL NEED: (scroll down for purchase options)
- XCR-4125 - Beige Pleather Cord 2mm (Faux Natural Color Leather) 3 Meters
Project uses 1 package. You will need 1 package.
- BWD-7452 -
Project uses 1 piece. You will need 1 package.
- BWC-265 - Golem Design Studio Ceramic Beads, 14mm Round Polka Dots, 2 Pieces, Lime Green
Project uses 2 pieces. You will need 1 package.
- BWC-266 - Golem Design Studio Ceramic Beads, 14mm Glazed Round Polka Dots, 2 Pieces, Light Blue
Project uses 2 pieces. You will need 1 package.
- FJR-5179 - Antiqued Brass Open Jump Rings 7mm 18 Gauge (50)
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5700 - Fiskars 5 Precision Tip Scissors - Super Sharp