Retired - Brass and Caramel Brown Swirl Heirloom Ornament

Cut two pieces of wire at an inch and a half long each, and one piece at two inches long.Make a simple wire loop at one end of each piece of wire, making them into eyepins.Onto one of the shorter eyepins, thread the largest bead cap, followed by the glass drop bead (narrow end first), and finally one of the small square bead caps, spread out.Make another simple loop and trim off excess wire.Onto the other short eyepin, thread a scalloped flower bead cap, the glass rondelle bead, and another scalloped flower bead cap.Make another simple loop and trim off excess wire.Onto the longest eyepin, thread a hobnail bumpy bead cap, the large round glass bead, and another hobnail bumpy bead cap.Make another simple loop and trim off excess wire.Thread a small mellon bead onto a headpin and make a simple loop. Trim off excess wire.Open the loop at the bottom of the drop bead and thread it through one of the loops on the large round bead, closing the loop once more.Open the loop at the other end of the large bead and thread that through the loop at one end of the rondelle. Close the loop again.Open the loop on the mellon bead and thread it through the other loop on the rondelle. Close loop once more.Tip: Check package quantities for each component. You may have extra material to make more than one finished project, or will have leftovers for other projects. In some cases, adding on just one more package of a component may be all you need to make multiple pieces.All designs © Beadaholique Inc.