Retired - Beautiful Day Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Remember to double all of the instructions to make both earrings. Using a toothpick or a piece of wire, spread a small amount of E6000 on the back of the cabochon and press it onto the pendant. Allow twenty-four hours for the glue to fully cure.
2. Make a simple loop at one end of each piece of wire. To one piece of wire, add a serpentine jade bead. To the other piece, add an Austrian crystal pearl. Make another simple loop at the opposite end of each piece of wire.
3. Open the loop at one end of the serpentine jade segment the same way you would open a jump ring and thread it through the loop on the pendant. Close that loop once more.
4. Open the loop at the other end of the serpentine jade segment and thread it through the loop at one end of the pearl segment. Close that loop once more.
5. Open the loop at the other end of the pearl segment and thread it through the loop on the earring hook. Close that loop once more.

• PND-5772 - Antiqued Silver Plated 18x13mm Oval Bezel Pendant Beaded Edge (1)
  Project uses 2 pieces. You will need 2 packages.


• BCP-4522 - Lucite Oval Cabochons 3D Light Blue Rose Cluster 18mm x 13mm (2)
  Project uses 2 pieces. You will need 1 package.


• SWP-3014 - Austrian Crystal, 5810 Round Faux Pearl Beads 3mm, 50 Pieces, Coral
  Project uses 2 pieces. You will need 1 package.


• WCR-2230 - Artistic Wire, Silver Plated Craft Wire 22 Gauge Thick, 8 Yard Spool, Tarnish Resistant Silver
  Project uses 4 inches. You will need 1 package.


• FEA-3015 - Silver Plated Fishhooks Earring Hooks (50)
  Project uses 2 pieces. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.