Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
This bracelet is adjustable. When sizing, simply measure the largest size needed to slip over the wrist. From there you will add the adjustable slider bead to wear comfortably. To modify the length, simply adjust the length of chain on both sides respectively. You will also need a scrap of thin wire or thread for this bracelet.
- Cut two 4.5 inch lengths of chain.
- Open one jump ring and attach it to the end of one length of chain. Attach one channel link and close the jump ring. Move to the other side of this link and attach the other length of chain with another jump ring. Close the jump ring.
- Using your thin scrap of wire or thread, thread on the one end links of the chain and using this wire as a needle thread it through the adjustable slider bead. Remove the wire. Slip the wire onto the other end link of chain and thread it though the slider bead criss crossing it so that the chains are coming out opposite ends of the bead.
- Finally take one charm and attach it to one end of the chain using a jump ring. Repeat on the other chain with a second charm.
WHAT YOU'LL NEED: (scroll down for purchase options)
- CHA-0180 - Gold Plated Bulk Chain, Tiny Rectangle Soldered Cable Links 3x2mm, By The Foot, Bright Gold
Project uses 9 Inches. You will need 1 package.
- BMB-021 - Adjustable Slider Clasp, Round with Silicone Center 8mm, 4 Pieces, Gold Tone
Project uses 1 piece. You will need 1 package.
- FJR-5240 - 22K Gold Plated Open Jump Rings 4mm 21 Gauge (x100)
Project uses 4 pieces. You will need 1 package.
- SWFA-1020 - Austrian Crystal, Gold Plated Channel Charm, 7mm, 8 Pieces, Crystal
Project uses 2 pieces. You will need 1 package.
- SWFA-1120 - Austrian Crystal, Gold Plated Channel Connector Link, 7mm, 4 Pieces, Crystal
Project uses 1 piece. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers