Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below, you will make one earring. Repeat all instructions to make the second earring.
- Using your flush cutters, cut a length of Austrian crystal crystal cup chain that is 8 cups long.
- Next, watch the video on How to Use Cup Chain Ends.
- Following what you learned in the video, attach a gold plated foldover cup chain crimp end onto either end of your cup chain length using your chain nose pliers.
- Next, open the loop on your earring hook (how you would a jump ring) and attach it onto the loop from one of your cup chain ends and close.
- Next, open a jump ring using your chain nose pliers and slide on the loop from your Nunn Design flower charm. Before closing, also slide on the loop from your second cup chain end and close.
- You're done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- PND-1091 - Nunn Design Decorative Charm, 18mm Art Deco with Rhinestone, 1 Pc, Ant. Gold
Project uses 2 pieces. You will need 2 packages.
- FEA-3020 - 22K Gold Plated Fish Hook Earring Hooks (50)
Project uses 1 pair. You will need 1 package.
- FCR-8010 - Gold Plated Foldover 24PP Cup Chain Crimp On Ends For Cup Chain (20 Pieces)
Project uses 4 pieces. You will need 1 package.
- FJR-5250 - 22K Gold Plated Open Jump Rings 5mm 20 Gauge (100)
Project uses 2 pieces. You will need 1 package.
- CHA-2021 - Austrian crystal Gold Plated Rhinestone Cup Chain 24PP Crystal - BY THE FT.
Project uses 3 inches. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose