Retired - Much Ado Earrings in After Party

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Open the jump rings to separate four links of gunmetal plated crystal channel chain, leaving a jump ring on each end.
2. Place a gunmetal plated 1.5", 22 gauge head pin through an 11mm dark gray teardrop faux pearl and create a wrapped wire loop after the bead.
3. Open the jump ring on one end of the chain and hang the pearl drop from it; close the ring.
4. Use a gunmetal plated 4mm, 21 gauge jump ring to hang the other end of the chain from the loop on a gunmetal plated ball post earring. Make sure you have the included jump ring on the chain and a second jump ring here so that the channel chain hangs properly.
5. Place a gunmetal plated earring back onto the earring post.
6. Repeat steps 1 - 5 to create a second earring.

• CHA-2017 - Austrian crystal Gun Metal Plated Channel Crystal Chain Black Diamond 6.8mm/ FT
  Project uses 1 piece. You will need 1 package.


• SWP-1162 - Austrian Crystal, 5821 Pear Shaped Faux Pearl Beads 11mm, 4 Pieces, Dark Grey
  Project uses 2 pieces. You will need 1 package.


• FEA-1071 - Gunmetal Plated Stud Earrings Ball Post & Ring 4mm (20)
  Project uses 2 pieces. You will need 1 package.


• FHP-5331 - Gun Metal Head Pins 1.5 Inches / 22 Gauge (50)
  Project uses 2 pieces. You will need 1 package.


• FJR-5294 - Gun Metal Plated Open Jump Rings 4mm 21 Gauge (100)
  Project uses 2 pieces. You will need 1 package.


• FEA-1014 -
  Project uses 2 pieces. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose