Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available,
may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND
OTHER SUPPLIES sections for current availability.
By following the instructions below, you will make one earring. Repeat all instructions to make the second earring.
- Open a jump ring and link it to your pear pendant. Close the jump ring.
- Onto an eye pin, place 1 4mm round erinite bead, 1 bead cap facing up, 1 round light siam bead, 1 bead cap facing down, and another round erinite bead. Create a simple wire loop after the last bead. Trim off excess wire. Make a total of two of these crystal links.
- To assemble your earring, start at the bottom. Open a loop on one end of one of the crystal links you just made and connect it to the jump ring attached to the pear pendant. Close the loop back up. On the other end of this same crystal link, open that loop and connect it to the loop on one side of your second crystal link. Close the loop back up. Move to the other side of that second crystal link and attach the earring hook by opening the loop at the base of it. Close the loop.
- All done! Enjoy!
WHAT YOU'LL NEED: (scroll down for purchase options)
- SWCR-6416 - Austrian Crystal, #6106 Pear Pendant 16mm, 2 Pieces, Light Siam Shimmer
Project uses 2 pieces. You will need 1 package.
- SWC-04594 - Austrian Crystal, #5000 Round Beads 4mm, 12 Pieces, Erinite Shimmer
Project uses 8 pieces. You will need 1 package.
- FEA-3070 - Silver Plated French Wire Earring Hooks 22mm (25 Pairs)
Project uses 1 pair. You will need 1 package.
- BMB-6453 - Bright Silver Plated Open Petal Flower Bead Caps 7mm (50)
Project uses 8 pieces. You will need 1 package.
- SWC-08597 - Austrian Crystal, #5000 Round Beads 8mm, 8 Pieces, Light Siam Shimmer
Project uses 4 pieces. You will need 1 package.
- FHP-6260 - Silver Plated Open Eye Pins 21 Gauge 1.5 Inch (x50)
Project uses 4 pieces. You will need 1 package.
- FJR-5459 - Silver Plated Open Jump Rings 5mm 21 Gauge (50)
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-3310 - The Beadsmith Casual Comfort, Chain Nose Pliers with PVC Handle, 1 Piece
- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece
- XTL-7213 - The Beadsmith Simply Modern Series, Round Nose Pliers, 4.75 Inches Long