Retired - Trisha Bangle

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Using a toothpick or scrap of wire place a dab of E6000 into the channel of the bangle. It is best to work in small sections.
2. Place the cup chain into the channel and press it down. Hold for a moment before moving on.
3. Add another stripe of glue to the channel with your applicator and continue to place the cup chain into the channel.
4. Work your way around the bangle.
5. When the two ends meet up clip off the excess cup chain with your flush cutters.
6. All done!

• CHA-10105 - Czech Crystal Brass Rhinestone Cup Chain 14PP Crystal (By The Foot)
  Project uses 9 Inches. You will need 1 package.


• JB-3001 - Nunn Design Bangle Bracelet, Circle with Channel 2 7/8 Inches, 1 Bangle, Antiqued Gold Plated
  Project uses 1 piece. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex