Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available,
may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND
OTHER SUPPLIES sections for current availability.
By following the instructions below, you will make one earring. Repeat all instructions to make the second earring.
- Onto a head pin place the following: 1 cube bead, 1 10mm margarita bead, 1 8mm margarita bead, 1 6mm margarita bead, and 1 bicone bead. Create a wrapped wire loop after the last bead.
- Open the loop on an earring hook the same way you would open a jump ring. Hang the earring from the hook by the loop you created, and then close the earring.
WHAT YOU'LL NEED: (scroll down for purchase options)
- FEA-3070 - Silver Plated French Wire Earring Hooks 18mm (25 Pairs)
Project uses 2 pieces. You will need 1 package.
- FHP-5320 - Silver Plated Head Pins 2 Inches Long/22 Gauge (X50)
Project uses 2 pieces. You will need 1 package.
- SWC-2412 - Austrian Crystal, 5601 Cube Beads 4mm, 10 Pieces, Crystal CAL (Comet Argent Light)
Project uses 2 pieces. You will need 1 package.
- SWBB-1312 - Austrian Crystal, 5328 Bicone Beads 3mm, 25 Pieces, Crystal CAL (Comet Argent Light)
Project uses 2 pieces. You will need 1 package.
- SWC-9700 - Austrian Crystal, 3700 Flower Margarita Beads 6mm, 12 Pieces, Crystal
Project uses 2 pieces. You will need 1 package.
- SWC-8540 - Austrian Crystal, 3700 Flower Margarita Beads 8mm, 12 Pieces, Peridot
Project uses 2 pieces. You will need 1 package.
- SWC-87535 - Austrian Crystal, 3700 Flower Margarita Beads 10mm, 6 Pieces, Dark Moss Green
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5032 - Beadsmith Wire Looping Pliers - Concave And Round Nose
- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex