Retired - Grandma's Black Diamond Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Use your chain nose pliers to slightly bend up 3 corners of the square filigree (PND-7028). (HINT: the square is dapped or indented already so the corners will already be bent slightly upward)
2. Lay the Rivoli crystal (SWC-9303) face up into the center of the square. It will lay right inside the dapped indentation nicely. Hold the rivoli with your fingers while you bend over 2 of the sides (opposite sides) pressing them gently on top of the rivoli crystal.
3. Now take the bottom corner with your fingers and gently push it up against the, but not over the rivoli.
4. Take your chain nose pliers and bend the tip of the bottom corner of the square back down slightly. This will allow you to hang a dangle.
5. Open a 4mm jump ring (FJR-5347). Link on a filigree charm (PND-7114). Link onto the bottom of the square filigree corner. Close jump ring.
6. Open the loop at the bottom of the leverback earring piece. Link on the top corner of your finished piece (FEA-6014) (see photo) Close loop.
7. Repeat the steps above to make the second earring.

• PND-7114 - Vintaj Natural Brass Filigree Teardrop Charms 12mm (2)
  Project uses 2 pieces. You will need 1 package.


• PND-7028 -
  Project uses 2 pieces. You will need 1 package.


• FEA-6014 - Antiqued Brass Earrings Leverbacks With Shell (5 Pairs)
  Project uses 2 pieces. You will need 1 package.


• SWC-9303 - Austrian Crystal, 1122 Rivoli Fancy Stones 12mm, 4 Pieces, Black Diamond Sf
  Project uses 2 pieces. You will need 1 package.


• FJR-5347 - Vintaj Natural Brass Jump Rings 4.75mm Open 19 Gauge (25)
  Project uses 2 pieces. You will need 1 package.