Retired - Fuego Verde Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Thread a 6mm bead on to two headpins and create a simple loop. trim off excess wire.
2. Thread a 4mm bead on to four headpins and create a simple loop, trim off excess wire.
3. Add the smaller dangles you have just created to the outermost holes on both rivoli bezels.
4. Add the larger dangles to the center holes on both rivoli bezels.
5. Using the same method you would use to open a jump ring, open the loops on each earring hook and thread through the single hole on each rivoli bezel and gently close the loop again.
6. Using a toothpick, dab a small amount of the E6000 glue on to the back of the rivolis and set into place in the bezels. Glue will set in about six minutes and full curing occurs within twenty-four hours.

• SWC-9330 - Austrian Crystal, 1122 Rivoli Fancy Stones 12mm, 4 Pieces, Crystal Vitrail Medium Sf
  Project uses 2 pieces. You will need 1 package.


• SWC-0404 - Austrian Crystal, 5000 Round Beads 4mm, 12 Pieces, Vitrail Medium
  Project uses 4 pieces. You will need 1 package.


• SWC-0604 - Austrian Crystal, 5000 Round Beads 6mm, 10 Pieces, Vitrail Medium
  Project uses 2 pieces. You will need 1 package.


• FEA-4030 - Bali Style 1 Ball Gold Plated Earring Hooks (50)
  Project uses 2 pieces. You will need 1 package.


• FHP-5216 - 22K Gold Plated Head Pins - 24 Gauge/1.5 Inches (X50)
  Project uses 6 pieces. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.