Retired - Fit for a Queen Adjustable Bangle

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by placing a dab of E6000 glue onto the center of your silver tone bezel setting. Carefully place your Crystal Austrian crystal fancy stone down onto the glue, faceted side up. Set aside to dry.
2. Using your chain nose pliers, open a jump ring silver plated jump ring and slide on the loop from your Nunn Design crown charm. Also slide on the bent wire loop that is on the left side of your adjustable wire bangle. See photo for placement assistance.
3. Next, open up another jump ring and slide on the loop from your rivoli bezel setting. Also slide you jump ring onto the bottom bar that is in the front of your bangle and close.
4. That�s it!

• JB-2578 -
  Project uses 1 piece. You will need 1 package.


• PND-05178 - Nunn Design Charm, 20x24.5mm Crown In Circle Bezel, 1 Piece, Bright Silver
  Project uses 1 piece. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.


• FCO-4406 - Silver Tone Pendant Setting For Austrian crystal 12mm Rivoli (1)
  Project uses 1 piece. You will need 1 package.


• SWC-9300 - Austrian Crystal, 1122 Rivoli Fancy Stones 12mm, 4 Pieces, Crystal SF
  Project uses 1 piece. You will need 1 package.


• FJR-5180 - Silver Plated Open Jump Rings 8mm - 18 Gauge (100)
  Project uses 2 pieces. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose