Retired - Fireworks Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Cut two lengths of chain at about seven inches long each and set them aside.
2. Using a toothpick or a piece of wire, dab a tiny amount of E6000 on the back of each of the rhinestones and carefully press them in the very center of each filigree. Set aside to dry for a few hours.
3. Using two jump rings between each filigree stamping, connect the red and blue filigrees to either side of the white filigree, not directly next to it but rather on an upward angle.
4. Connect each piece of chain to each end of the filigree center piece using one jump ring per end.
5. Add a jump ring to the opposite end of both pieces of chain, and add a lobster clasp to one of the jump rings before closing it.

• PND-00114 - Red Color Coated Brass Stamping By Ezel - Round Filigree Pendant 31mm
  Project uses 1 piece. You will need 1 package.


• PND-00118 - White Color Coated Brass Stamping By Ezel - Round Filigree Pendant 31mm
  Project uses 1 piece. You will need 1 package.


• SWF-12003 -
  Project uses 3 pieces. You will need 1 package.


• CHA-9652 - Gunmetal Steel Textured Cable Chain 2.3mm Bulk By The Foot
  Project uses 2 feet. You will need 1 package.


• FCL-2511 - Gunmetal Plated Curved Lobster Clasps 8mm (10)
  Project uses 1 piece. You will need 1 package.


• FJR-5296 - Gun Metal Plated Open Jump Rings 6mm 19 Gauge (100)
  Project uses 8 pieces. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.