Retired - Evening In The City Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Measure an 18" length of chain and use your flush cutters to cut your chain.
2. Separate the two parts of your barrel clasp.
3. Open the end loop of one part of your barrel clasp, just as you would open a jump ring, and link it to the end chain link of your cut piece of chain. Close the end loop back up.
4. Going from the end of the chain that does not have the clasp on it, place 11 gold plated stardust sparkle 10mm round beads. Attach the other side of your barrel clasp to the last link of chain on this end.
5. Have fun wearing this pretty necklace.

• CHA-9708 - Gunmetal Steel Round Rolo Chain 2mm Bulk By The Foot
  Project uses 18 inches. You will need 2 packages.


• BMB-1820 - 22K Gold Plated Stardust Sparkle Round Beads 10mm (20)
  Project uses 11 pieces. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex