Retired - Enchanted Evening Hair Clip

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by gently bending your flat filigree to match the slightly curved shape of the hair barrette.
2. Turn the filigree over and using a toothpick or piece of wire as an applicator, place E6000 glue on all parts of the filigree which will make contact with the metal of the hair barrette. Turn over and press into place.
3. At this point I would recommend letting your glue dry for about an hour so that the filigree does not move around on you, however, if you are comfortable with it's current stability, you can move onto the next step.
4. Place some E6000 onto the backside of one of your large ss48 Austrian crystal crystal flat back rhinestones. Flip over and press into the middle of the teardrop openwork hole of your filigree which lies directly over the barrette bar. Press into place. Repeat this step with another ss48 rhinestone on the other side of the filigree, again, over the barrette bar.
5. Now take a dab of E6000 and place it next to each of the large rhinestones you just placed, right onto the exposed barrette bar besides them (going in the direction of the edge). Into these dabs of glue, place 1 ss34 Austrian crystal crystal flat back rhinestone.
6. Looking at your filigree piece, you will see that you have two large teardrop shape open work holes which have no rhinestones in them and run in the opposite direction of the ones sitting ontop of the barrette bar. At the very peak of each of these, up near the outer edge of the filigree, place a dab of E6000. Into these dabs of glue, place 1 ss34 flat back rhinestone into each.
7. For all your remaining rhinestones, including the smallest size ss12 Austrian crystal crystal flat back rhinestones in black diamond AB, place them where ever you like on the filigree. So place some glue, then stick a rhinestone into the glue, place more glue, another rhinestone, etc. One thing I chose to do was place rhinestones over any portion of the exposed barrette bar. You can do this too if you like. Have fun with this step and let your creativity flow.
8. Once you have placed all your rhinestones, let the E6000 glue fully dry before wearing - at least 24 hours.
9. Enjoy!

• FCO-9017 - Silver Tone French Barrette Hair Clips - Fun Craft Beading Project 2 1/4 Inches (10 Pack)
  Project uses 1 piece. You will need 1 package.


• PND-5723 - Antiqued Silver Plated Full Openwork Flower Filigree Stamping 62mm (1)
  Project uses 1 piece. You will need 1 package.


• SWF-11220 -
  Project uses 28 pieces. You will need 1 package.


• SWF-43400 - Austrian Crystal, Round Flatback Rhinestone SS34 7mm, 12 Pieces, Crystal
  Project uses 4 pieces. You will need 1 package.


• SWF-44800 - Austrian Crystal, Round Flatback Rhinestone SS40 8.5mm, 4 Pieces, Crystal
  Project uses 2 pieces. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.

• XTL-4004 - Beadsmith Magical Rhinestone Pick Up Tool With Cleaning Kit - Great For Placing Flatback Rhinestones