Retired - Dragonscale Chain Maille Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Watch the instructional video: How to Make Dragonscale Chain Maille. This video will demonstrate the dragonscale weave that you will use to make this bracelet.
2. Using silver plated 18 gauge chain maille rings with an inner diameter of 15/64" and brass 20 gauge chain maille rings with an inner diameter of 9/64", make a length of dragonscale chain maille that is four large rings wide and about the same length as your wrist measurement, with both ends tapered down to one ring.
3. Use one of the brass rings to attach both rings from one end of the bracelet to half of a silver plated magnetic clasp. Use another brass ring to attach both rings from the other end to the other half of the magnetic clasp.

• FMC-1594 - Artistic Wire, Chain Maille Jump Rings, 18 Ga / ID 5.95mm / 45pc, Tarnish Resistant Silver Plated
  Project uses many pieces. You will need 7 packages.


• FMC-2353 - Artistic Wire, Chain Maille Jump Rings, 20 Ga / ID 3.57mm / 140pc, Tarnish Resistant Gold Tone Brass
  Project uses many pieces. You will need 3 packages.


• FCL-6808 - Silver Plated Magnetic Clasps 6 x 4.5mm (4 Sets)
  Project uses 1 set. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose