Retired - Celestina Ring

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Before you begin, watch the video on How to Use Crystal Clay .
2. Following what you learned in the video, put on your gloves and mix a gumball sized amount of white Crystal Clay.
3. Fill your Nunn Design ring with clay, making sure to leave enough room for the Austrian Crystal as well as the strip of cup chain.
4. Using your flush cutters, cut a 28 cup length of opal cup chain.
5. Place your Austrian crystal crystal fancy stone into the center of the clay. Carefully push in, remembering to leave room along the edges.
6. Add on your strip of cup chain. Push the chain in and try not to get any clay outside of the bezel. I placed my cup chain slightly on its side to give a "scalloped bezel" look to my ring.
7. Keep your ring upright to cure over night.
8. You're done!

• CHA-10134 - Czech Crystal Brass Rhinestone Cup Chain 12PP White Opal (By The Foot)
  Project uses 3 inches. You will need 1 package.


• SWCR-4104 - Austrian Crystal, 4127 Oval Fancy Stones 30x22mm, 1 Piece, Crystal Paradise Shine F
  Project uses 1 piece. You will need 1 package.


• FRG-1036 - Nunn Design Deep Bezel Ring, Oval 23x30mm, 1 Ring, Antiqued Gold
  Project uses 1 piece. You will need 1 package.


• TRC-251 - Crystal Clay 2-Part Epoxy Clay Kit 'White' 25 Grams
  Project uses 1 piece. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex