By following the instructions below, you will make one earring. Repeat all instructions to make the second earring.
- Open the jump ring attached to the charm and remove it from the charm. Discard this jump ring, you will not need it for this project.
- Take your flat nose pliers to bend the flattened end of the beading hoop up.
- Onto the beading hoop, string one black seed bead, one angel wing, followed by 48 seed beads.
- To the end of this beading hoop, make a simple wire loop. Trim the excess wire with your flush cutters.
- Open the loop of the earring hook, the same way you would a jump ring and thread it through the hole at the top of the beading loop. Close the loop.
- All Done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- JSK-0242 - Toho Round Seed Beads 11/0 49F 'Opaque Frosted Jet' 8 Gram Tube
Project uses 1 tube. You will need 1 package.
- PND-10500 - Silver Plated and Enameled Charm, Angel Wing (Left) 24x9x3mm, 1 Piece, Black
Project uses 1 piece. You will need 1 package.
- PND-10563 - Silver Plated and Enameled Charm, Angel Wing (Right) 24x9x3mm, 1 Piece, Black
Project uses 1 piece. You will need 1 package.
- FEA-3015 - Silver Plated Fishhooks Earring Hooks (50)
Project uses 2 pieces. You will need 1 package.
- FEA-7107 - Silver Plated Beading Hoop Earrings 1 1/4 Inch (20)
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex