Retired - Myrine Elegance

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. To begin cut your small gold crinkle chain into two 6" pieces. Make sure the chain is all going to same way with the smaller links on top of the larger links on both sides of the necklace.
2. In one of the larger holes of the chain, open a silver jump ring attach it to the gold crinkle chain and one of the rectangular connectors. Close the jump ring.
3. On the other side of the connector open another silver jump ring and attach it around the connector and the last link on the end of the gold leaf chain. Close the jump ring.
4. Repeat this process for the other side of the necklace: gold crinkle chain attached with silver jump ring to the silver connector, attached by silver jump ring to the other side of the gold leaf chain.
5. To finish the necklace, carefully trim off, using your flush cutters, one of the small loops in the crinkle chain.
6. On one side of the chain open and close a matte gold jump ring around the last link. On the other side, open and close a matte gold jump ring around the chain making sure to slide on the lobster clasp before closing.

• BMB-3397 - TierraCast Real Rhodium Plated Pewter Rectangle 18mm Connector Link Ring (2)
  Project uses 2 pieces. You will need 1 package.


• CHA-98832 - Matte Gold Plated Teardrop Krinkle Chain 2mm Bulk By The Foot
  Project uses 12 inches. You will need 1 package.


• CHX-2007 - Matte Gold Plated 7mm Leaf Charm Chain - Bulk By The Inch
  Project uses 12 inches. You will need 12 packages.


• FJR-3906 - Silver Plated Open Jump Rings Oval 4x6mm 20 Gauge (50)
  Project uses 4 pieces. You will need 1 package.


• FJR-3100 - Matte 16K Gold Plated Open Jump Rings 6mm 20 Gauge (50)
  Project uses 2 pieces. You will need 1 package.


• FCL-2539 - Matte Gold Plated Sleek Lobster Claw Clasps 12mm (6)
  Project uses 1 piece. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex