Remember to double these directions to make your matched pair of earrings.
- Cut the head off of an antique copper head pin. Create a simple wire loop at the end that you cut the head off of.
- Measure and cut 3" of chain.
- Thread the chain through the hole in the Golem pendant. Pull the chain so that the pendant is in the middle and the chain is not twisted.
- Open the simple wire loop that you made in the first step and link onto it both ends of your chain from the previous steps. Close the loop.
- Place a Czech glass 5mm round melon bead onto the wire that is sticking up from the chains/pendant. Create a simple wire loop right after the bead. Trim off excess with flush cutters.
- Open the loop at the base of your earring hook. Link onto this loop the simple wire loop you made in the last step. Close the earring loop back up.
- All done! Enjoy your pretty new pair of earrings.
WHAT YOU'LL NEED: (scroll down for purchase options)
- FEA-3018 - Genuine Antiqued Copper Fish Hook Earring Hooks 16mm (24)
Project uses 2 pieces. You will need 1 package.
- BCP-1164 - Czech Pressed Glass - Round Melon Beads 5mm 'Opaque Olive/Marbled Gold' (50)
Project uses 2 pieces. You will need 1 package.
- FHP-1052 - Genuine Antiqued Copper Head Pins 24 Gauge 2 Inches (24)
Project uses 2 pieces. You will need 1 package.
- BWC-553 - Golem Design Studio Ceramic Pendant, 19mm Glazed Disc Ladybug, 2 Pieces, Green/Red
Project uses 2 pieces. You will need 1 package.
- CHA-9815 - Nunn Design Antiqued Copper Plated Oval Cable Chain 3mm By The Ft
Project uses 1 foot. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers