Retired - Love Knot Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by stringing one 12mm heart crystal on to a head pin, with the bottom of the heart facing down. Make a simple wire loop.
2. Attach this simple wire loop by opening it, the same way you would a jump ring, to the pewter love knot ring so that it hangs on the inside of the ring. Close the loop.
3. String one 8mm heart crystal on to an eye pin. Make a simple wire loop.
4. Attach the bottom loop of this heart to the top side of the ring, to the same hole where you have attached the 12mm heart. Close the loop.
5. Open the loop above the 8mm heart and attach it to the earring finding. Close the loop.
6. All done!

• FEA-3084 - Silver Plated French Wire Earring Hooks 16mm (25 Pairs)
  Project uses 2 pieces. You will need 1 package.


• SWCR-5137 - Austrian Crystal, 5741 Love Heart Bead 8mm, 2 Pieces, Light Siam
  Project uses 2 pieces. You will need 1 package.


• SWCR-5145 - Austrian Crystal, 5741 Love Heart Bead 12mm, 2 Pieces, Light Siam
  Project uses 2 pieces. You will need 1 package.


• BMB-1013 - Lead-Free Pewter, Love Knot Ring Beads 20mm, 2 Pieces, Antiqued Silver
  Project uses 2 pieces. You will need 1 package.


• FHP-5323 - Silver Plated Head Pins 1.5 Inches Long/21 Gauge (x50)
  Project uses 2 pieces. You will need 1 package.


• FHP-6260 - Silver Plated Open Eye Pins 21 Gauge 1.5 Inch (x50)
  Project uses 2 pieces. You will need 1 package.

• XTL-5032 - Beadsmith Wire Looping Pliers - Concave And Round Nose
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose