Retired - Jody Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Cut lengths of silver rolo chain 1.25", 1", 2", 0.5" and 1". Cut two additional lengths 9" each. Set aside the two 9" chains.
2. Onto a silver head pin, place a Pink faceted nugget. Make a simple wire loop. Open the simple wire loop (the same way you would open a jump ring) and link it to the end chain link of the 1.25" chain. Repeat this for the other four short pieces of chain.
3. Taking the five chains with the gems on them, place a 5mm, 18 gauge silver jump ring onto the other end of each chain. Do not close the jump rings yet.
4. You will close the jump rings around the silver connector circle in this order: 1.25", 1", 2", 0.5" and 1". Gather all the chains at the bottom point in the connector link.
5. Take the one piece of 9" chain and place a jump ring on one end, close it around the top right of the silver connector circle. On the other side of this chain, attach a jump ring and close it.
6. Take the other piece of 9" chain and place a jump ring on one end, close it around the top left of the silver connector circle. On the other side do this chain, attach a jump ring and 10mm silver lobster clasp and close the jump ring.

• SPAG-164 - Pink Crazy Lace Agate (D) Faceted Nugget Gem. Beads 9-12mm (10 Beads)
  Project uses 5 pieces. You will need 1 package.


• BMB-3758 -
  Project uses 1 piece. You will need 1 package.


• FHP-5314 - Silver Plated Head Pins 1 Inch/22 Gauge (50)
  Project uses 5 pieces. You will need 1 package.


• FCL-2513 - Beautiful Silver Plated Curved Lobster Clasps 10mm (10)
  Project uses 1 piece. You will need 1 package.


• FJR-5159 - Silver Plated Open Jump Rings 5mm 18 Gauge (50)
  Project uses 9 pieces. You will need 1 package.


• CHA-9953 - Silver Plated Round Rolo Chain 3.7mm Bulk By The Foot
  Project uses 2 FEET. You will need 2 packages.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex