By following the instructions below, you will make one earring. Repeat all instructions to make the second earring.
- Using your chain nose pliers, open the loop at the bottom of your gold plated earring hook (how you would a jump ring) and slide on the loop that is at the top of your gold plated chandelier earring finding and close.
- Next, onto a gold plated ball head pin, slide on 1 simulated ruby glass bead and create a wrapped wire loop using your round nose pliers. Snip off any excess wire using your flush cutters.
- Repeat this step 5 more times.
- Then, using your chain nose pliers, open a 3mm gold plated jump ring and slide it through the wrapped wire loop from one of your bead dangles. Also slide the jump ring through a loop in the filigree on the left side of your earring finding. Refer to the photo for exact placement.
- Repeat adding bead dangles onto your earring finding via open jump rings and close.
- That's it!
WHAT YOU'LL NEED: (scroll down for purchase options)
- FEA-8403 - 22K Gold Plated 25mm Hoops For Chandelier Earrings 5 Pair
Project uses 2 pieces. You will need 1 package.
- FEA-3071 - 22K Gold Plated French Wire Earring Hooks 18MM (25 Pairs)
Project uses 2 pieces. You will need 1 package.
- FJR-5230 - 22K Gold Plated Open Jump Rings 3mm 22 Gauge (x100)
Project uses 12 pieces. You will need 1 package.
- FHP-3027 - 22K Gold Plated Ball Head Pins 22 Gauge 1.5 Inch (x20)
Project uses 12 pieces. You will need 1 package.
- BGL-08001 - Simulated Ruby Glass Beads, 2.5X3.5mm Faceted Rondelles, 15.5 Inch Strand, Ruby Red
Project uses 12 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers