By following the instructions below, you will make one earring. Repeat all instructions to make the second earring.
- Using your flush cutters, cut a 1 inch length of Nunn Design antiqued gold plated chain. Set aside.
- Next, onto a gold plated ball head pin, slide on a black Swarovski artemis cone bead, followed by a Swarovski crystal rondelle bead and another black Swarovski artemis cone bead. Also slide on the last link from one side of your chain length.
- Create a wrapped-wire loop with your round nose pliers and snip off any excess with your flush cutters.
- With your chain nose pliers, open the loop on your earring hook (how you would a jump ring) and slide on the last link from the other end of your chain length and close.
- That�s it!
WHAT YOU'LL NEED: (scroll down for purchase options)
- CHA-9814 - Nunn Design Antiqued Gold Plated Oval Cable Chain 3mm By The Foot
Project uses 2 inches. You will need 1 package.
- FEA-3020 - 22K Gold Plated Fish Hook Earring Hooks (50)
Project uses 2 pieces. You will need 1 package.
- FHP-3023 - 22K Gold Plated 2mm Ball Head Pins 21 Gauge 3 Inches (x20)
Project uses 2 pieces. You will need 1 package.
- SWC-2344 - Swarovski Crystal, 5540 Artemis Cone Bead 17mm, 1 Piece, Jet
Project uses 2 pieces. You will need 2 packages.
- SWC-5186 - Swarovski Crystal, 9001 Rondelle Beads 10x3.7mm, 2 Pieces, Gold Plate With Crystal
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose