Retired - Dear Daisy Ring in Black

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Before you begin, watch the video: How to Make a Dagger Bead Daisy Ring. This video will demonstrate the steps for making this project.
2. String 10 black 3x10mm dagger beads onto a 2' length of black Wildfire beading thread and tie a knot a few inches from the tail end of the thread.
3. Bring your needle through the next dagger bead, then string a 4mm aurum gold druk bead.
4. Enter the dagger beads directly across from where you exited them and bring your needle through the next 5 dagger beads moving in the opposite direction as before.
5. Go back through the druk bead, then go through the other 5 dagger beads back in the original direction. Tie off and weave in your thread.
6. Place a thin layer of E6000 glue onto the glue pad of an antique brass adjustable ring.
7. Center the beaded daisy onto the glue pad and press into place. Make sure that it's centered and that the "petals" are arranged evenly.
8. Allow the glue to dry thoroughly before wearing.

• BCP-10014 - Czech Glass 3 x 10mm Dagger Spear Beads 'Matte Jet' (50)
  Project uses 10 pieces. You will need 1 package.


• BCP-7408 - Czech Glass Druk 4mm Round 'Rare Aurum Gold' (100)
  Project uses 1 piece. You will need 1 package.


• FRG-0883 - Antiqued Brass Adjustable Ring With 12mm Glue On Plate (4)
  Project uses 1 piece. You will need 1 package.


• XCR-8936 - Wildfire Thermal Bonded Beading Thread .008 Inch - Black- 50 Yd
  Project uses 2 feet. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 tube. You will need 1 package.

• XTL-3005 - Beadsmith English Beading Needles Size 10 - 4 Needles
• XTL-0106 - BeadSmith Cordless Thread Zap II Thread Burner Tool