Retired - Copper Lady Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Remember to double all of the instructions in order to make both earrings. Onto a headpin thread the following:
2. a tiny copper scalloped bead cap (BMB-3289), concave side up
3. a 7mm copper open petal flower bead cap (BMB-6455), concave side up
4. an 8mm two toned brown and crystal Czech fire polish bead (BCP-38100)
5. a 6mm copper cone flower bead cap (BMB-6461), concave side down
6. a 9mm copper plated triple point bead cap (BMB-3854), concave side down
7. an 8mm copper plated granulated flower bead cap (BMB-3860), concave side up
8. a 7mm copper open petal flower bead cap (BMB-6455), concave side up
9. a 6mm two toned brown and crystal Czech fire polish bead (BCP-38100)
10. another tiny copper scalloped bead cap (BMB-3289), concave side down
11. Create a wrapped wire loop and trim off excess wire.
12. Open the loop on the earring hook the same way that you would open a jump ring. Thread the earring hook loop through the loop on the headpin. Close the earring hook loop again.

• BMB-6461 - Genuine Copper Cone Flower Bead Caps 6mm x 3.5mm (50)
  Project uses 2 pieces. You will need 1 package.


• BMB-3289 - TierraCast Copper Plated Pewter Scalloped Bead Caps 3.5mm (x 12)
  Project uses 4 pieces. You will need 1 package.


• BMB-6455 - Genuine Copper Open Petal Flower Bead Caps 7mm (50)
  Project uses 4 pieces. You will need 1 package.


• BCP-36100 - Czech Fire Polished Glass Two Toned Beads 6mm Round Brown Crystal (25)
  Project uses 2 pieces. You will need 1 package.


• BCP-38100 - Czech Fire Polished Glass Two Toned Beads 8mm Round Brown Crystal (25)
  Project uses 2 pieces. You will need 1 package.