Retired - Cecily Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Place an 8 mm light blue chalk turquoise round bead onto a 2", 21 gauge black plated brass head pin. Use a pair of round nose pliers to create a simple wire loop after the bead.
2. Use a 6 mm, 20 gauge black finish pewter oval jump ring to hang the bead from one of the holes on a black finish pewter rectangle connector link.
3. Use a second jump ring to attach a black finish pewter stud earring dome post to the second hole on the connector link.
4. Place a gunmetal plated earring back on the back of the post.

• BMB-3884 -
  Project uses 2 pieces. You will need 1 package.


• FEA-1014 -
  Project uses 2 pieces. You will need 1 package.


• FEA-1580 - TierraCast Black Finish Pewter Stud Earrings Dome Post & Ring 8mm
  Project uses 2 pieces. You will need 1 package.


• FHP-7121 - TierraCast Black Plated Brass Head Pins 2 Inches / 21 Gauge (x50)
  Project uses 2 pieces. You will need 1 package.


• FJR-6000 - TierraCast Black Finish Brass Open Oval Jump Rings 6mm 20 Gauge (50)
  Project uses 4 pieces. You will need 1 package.


• SPTU-20 - Light Blue Chalk Turquoise Round Beads 8mm Stabilized /15.5 Inch Strand
  Project uses 2 pieces. You will need 1 package.

• XTL-0074 - Eurotool Nylon Jaw Pliers Chain Nose- For Scratch-Free Wire Work
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex